Home > Western Digital > Western Digital Error Code 223

Western Digital Error Code 223

Contents

If ECC occurs, use Data Lifeguard repair option for additional error correction. Re-Test Drive 4 Open Drive Failure Cannot communicate with drive. Check if the address is correct. Generated Fri, 29 Jul 2016 02:04:29 GMT by s_rh7 (squid/3.5.20) have a peek here

Re-Test Drive 100 Errors Found A Read or Write command during the test has failed. Re-test with appropriate diagnostic utility 0001 - 0008, 0015 SMART Error Self-Monitoring, Analysis, and Reporting Technology (SMART) Error returned during SMART Status/Self Test Command. You may need to rescan to ensure that the repairs were effective. Re-test Drive 136 Bad Sector Sector Marked Bad Error. https://support.wdc.com/knowledgebase/answer.aspx?ID=11711

Western Digital Error Codes

Replace Drive 211 Self Test Never Completed The drives internal self-test could not complete due to unrepairable errors. Retest. This drive is the first drive I've ever encountered where dlgdiag just reports errors and fixes them only to say/do the same thing again next time I run it. Hit any key to retry' error.

This error may also be related to memory issues. Several instances of information on data positioning and location could not be found. Replace the drive if the error repeats. The thing is, the tool isn't giving any S.M.A.R.T.

This may be an anomaly or a defect with the drive. Western Digital Error Code 0007 Retest. ABOUT About Us Contact Us Discussion Forum Advertising Privacy Policy GET ARTICLES BY EMAIL Enter your email address to get our daily newsletter. https://community.wd.com/t/wd20ears-00s8b1-strange-smart-behavior/14205 Replace Drive 226 Sector Relocation Error Failure to relocate a sector during drive repair.

Check cabling and retest. Re-test Drive 220 Drive is Locked Security feature of the drive reports locked status. This may be an anomaly. Replace the drive if the error repeats.

Western Digital Error Code 0007

Can anyone, please, help me out? http://www.tomshardware.com/forum/250912-32-read-error-rate Newer Than: Search this thread only Search this forum only Display results as threads More... Western Digital Error Codes It also may be due to a defective connection. Several instances of track information could not be found.

There may be repairable media errors on a platter. navigate here Re-Test Drive 105 BUSY GLITCH The drive did not properly respond to test commands. Irv S. There are too many errors detected on this drive to be repaired.

Don't forget to share! Retest and replace the drive if the error repeats. daringjoe, see above edit. Check This Out Re-test the drive with Data Lifeguard.

Replace Drive 163 Unknown Error Queued command timed out. This may be due to a media or read/write error. This error is most likely an internal malfunction of the drive and not related to the condition of the cables etc.

I'd be grateful if you can compare the the two drives for me -- as I'm not too good at this -- and let me know if there's any difference in

The raw read error rate doesn't seem to be well on the smart scan and I would like to know more about this. An error has been detected. Edit by mod. Retest after checking the connections.

Could it be an issue with installing WinXP under FAT32? Re-test Drive 201 Non-WD Drive The drive does not have a WD serial number. Drive should be replaced. this contact form The same utility and the original code used to lock the drive are necessary to unlock this drive.

Any kind of help would be appreciated. Retest after checking the connections.