Home > Western Digital > Western Digital Error Status Code 0226

Western Digital Error Status Code 0226

It hit two sectors that had gone bad and it just so happens that these two sectors contain Windows XP's boot files, nothing new that hasn't been backed up. WD Raptor / RAID Opinion Needed WD Raptor 10K RMP versus new 7K RPM Platter versus new SSD Weird problem with P5B Deluxe/WD Raptor WD_Raptor HD WD Raptor Alternatives (Raid0) (1)150 If ECC occurs, use Data Lifeguard repair option for additional error correction. Re-test with appropriate diagnostic utility 228 DRIVE IS LOCKED-DST FAIL Security feature of the drive reports locked status. have a peek here

Replace Drive 219 Drive Cable Error Failure during cable test. Re-test Drive 138 Still Busy Timeout Timeout from checking busy bit. Retest. Drive should be replaced. https://support.wdc.com/knowledgebase/answer.aspx?ID=11711

When I pressed quit, it said drive failed the DST, error: 0222. there is a very good chance that you will be able to see everything on the drive and all you need to do is cut and paste the files to the Drive should be replaced. Spinrite is too, but when I run it the program gets to the point where it starts reading the drive and then that clicking noise starts putting Spinrite into an eternal

Re-Test Drive 107 Check Sum Error Accumulated test data on the drives is corrupted. Problems with new Western Digital Raptor Drives Can't find your answer ? Browse other questions tagged hard-drive hardware-failure smart or ask your own question. sminlalSep 6, 2009, 8:01 PM i_hate_flying said: I've just successfully recovered all my critical files!

Drive should be replaced. Securing a LAN that has multiple exposed external at Cat 6 cable runs? If this computer is still under warranty the manufacturer will replace it. you could check here I would like to test it before use.

Return to Top Data Lifeguard Tools 5.22 for DOS Error Codes Note: If the same error code is encountered more than once after re-testing, please Contact Us for additional assistance. Retest and replace the drive if the error repeats. Like I said, I have not been getting any kind of "non-system disk" error when I put in a floppy, so I do not know if it will read it (this after finishing the extended test, it said that error could not be repaired and gave me an error code 0226.

It stays at the blankscreen with a blinking cursor, and the floppy disk light goes on as well which is quite odd. https://community.wd.com/t/sector-relocation-error-code-0226/13529 I'm running Windows XP. Re-test Drive 143 RANDOM SEEK ERROR Error encountered during random seek. Re-test Drive 206 Memory Allocation Error Unable to allocate memory for program structures.

So I press the reset button and rebooted. navigate here The drive may not have been accessed properly possibly due to a bad connection. Retest after checking the connections. Offline surface scan supported.

One instance of information on data positioning and location could not be found. Replace Drive 207 SMART status failed before the media scan. Drive should be replaced. Check This Out Replace the drive if the error repeats.

Re-test Drive 137 Relocated Sector Sector Relocated. Trick or Treating in Trutham-And-Ly How to defeat the elven insects using modern technology? To run in ATA 66 and ATA100 rates, an Ultra ATA 80 -conductor cable must be used.

Replace the drive.

Re-Test Drive 20 Failed to Delete Partitions A Device I/O Control command during the test has failed. XP wont boot, blank screen after post mesage, i can easily read all files on other computer? It was lying on a shelf. If the error repeats, replace the drive.

To recap, this all started with it not detecting the hard drive. It is testing right now so I will post back when it's done. Check the drive connections. http://3cq.org/western-digital/western-digital-error-code-0226.php It seems that a portion of the disk is physically damaged.

This error may have internal and external reasons. it may be failing hardware. Back to top #40 dc3 dc3 Arachibutyrophobia Members 26,402 posts OFFLINE Gender:Male Location:Sierra Foothills of Northern Ca. Any suggestions?

Style Default Style Contact Us Help Home Top RSS Terms and Rules Copyright © TechGuy, Inc. This may be due to a media error. Lowyat.NET forums Advertisement Lowyat.NET Kopitiam Garage Sales Lowyat.NET Rules and Regulations FAQ HelpSearchMembersCalendar Welcome Guest ( Log In | Register ) Lowyat.NET->Computers->Technical Support Bottom 0 new posts since last i never have large capacity drive as my main hard drive (except for experimenting) , that forces you to move large volumes of music, pictures, video (anything you want to save)

This may be due to a defect with the drive or a bad connection. If you're not already familiar with forums, watch our Welcome Guide to get started. rosh325, Sep 13, 2007 #15 Sponsor This thread has been Locked and is not open to further replies. Username Forum Password I've forgotten my password Remember me This is not recommended for shared computers Sign in anonymously Don't add me to the active users list Privacy Policy


Re-test Drive with appropriate diagnostic utility 204 Missing Log File The log file that existed at startup of diagnostic utility has been moved or no longer exists. Unfortunately, as I type this, it seems that things have frozen up a bit and they don't seem to be transferring at the moment.... The cable is loose, broken, or not plugged in. I was rather surprised that it wasn't more detailed.